Re: Re: Upper bolster bearing on H

Posted by John C. on September 12, 2000 at 09:29:52 from (205.188.196.51):

In Reply to: Re: Upper bolster bearing on H posted by Farmer Bob on September 11, 2000 at 19:47:35:

I was glad to read your directions. I want to
replace that same bushing in the upper bolster of
my H, but I can't get the shaft to drop out of the
half gear. I even have the front wheels hanging on
the shaft to provide some weight. Another helpful
person suggested heat, but since I don't have a
torch I was trying to figure some other way.
Your's seemed to drop out easily. Did you have any
special trick other than brut

Follow Ups:

• Re: Re: Re: Upper bolster bearing on H Andy Martin 11:27:10 09/12/00 (1)
  • Re: Re: Re: Re: Upper bolster bearing on H John C. 11:35:55 09/12/00 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Re: Upper bolster bearing on H Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]