Farmall & IHC Tractors Discussion Board |
Re: lubricant to use in Super-A distributor drive housing
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chris on September 11, 2000 at 13:52:33 from (205.215.115.42):
In Reply to: lubricant to use in Super-A distributor drive housing posted by Kendall on September 11, 2000 at 11:26:28:
On my Cub distributor, which is similar if not identical to yours, I screw in grease zerks (I have two grease locations) and pump in good old chassis grease. One grease point is on the skinny neck, and the other is on the gear housing. The magnetos, I believe, have little cups that you'd put a few drops of engine oil in. Chris
Follow Ups:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|