The reason I ask is that I have one in a 400 that had been destroyed over the years from being taken out and put in over and over, I guess to clean the screen. When the last guy put it back in, he must have used an inpact wrench, cause I really killed it getting it out. I made another from a hollow brass plug I filled with lead, (soldered in the screen too) I used a hacksaw and cut a clean slot, now I need a hole, but the smallest bit I have is a #52 orfice bit, which is a little bigger. I'll check at one of the gas companys and see if the service guy has a smaller one. Thanks for the info!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - When Push Comes to Shove - by Dave Patterson. When I was a �kid� (still am to a deree) about two I guess, my parents couldn�t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He�s been run over by a train, he�s gone forever!" Where did they find me? Perched up on the seat of the tractor. I�d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this �green planet�. I�m par
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
