Farmall & IHC Tractors Discussion Board |
Re: what pulley for farmall 300?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Thor on September 08, 2000 at 10:16:39 from (208.140.0.138):
In Reply to: what pulley for farmall 300? posted by Paul on September 08, 2000 at 06:39:36:
Paul, Actually four different pulleys were offered for the 300's. The differences were pulley diameter and face width. As standard you would get a 9 3/4" dia. x 7 1/2" wide face (p/n 358398 R93). But you could also get a 9 3/4" x 8 1/2" (p/n 358396 R93), a 11" x 7 1/2" (p/n 358397 R93), or a 12" x 8 1/2" (p/n 358597 R92). I've got a couple of 300 row crops and have been looking for 2 point implements. Do you have any that you want to sell or do you know where I could find some? Where are you located? E-mail me if you want. Good luck Thor
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|