Posted by Dwhitt03 on January 13, 2012 at 05:42:11 from (68.209.175.174):
In Reply to: Farmall 140 value posted by Erik ok on January 12, 2012 at 18:03:03:
I just bought a 1969 140 with Fast Hitch and 1A-60 Front Mounted Grader Blade for $1,075.00. Had to drive 330 miles from NC to MD to pick it up, so cost another $100.00 in gas and a day of my time.
It would run with choke out, but only a low idle. Ran well enough to get it on the trailer and get it home. $20.00 carb kit and cleaning and it starts good and runs but smokes. I am sure it will need a rebuild.
It has two almost new Firestone Road and Field tires on the back, still have the molding marks and flashings. It has only one wheel weight on the back, the right side is missing.
Has the Deluxe seat.
Clutch seems good.
I sold the grader blade for $400.00.
The front end sheeet metal is really bad, missing the "chin" under the grill housing so I am looking for some sheet metal. Doesn't have to be show quality, just good enough to bolt on to tractor for now.
There is a Fast Hitch being advertised locally for $899.00. Fast Hitches usually sell for $700.00 or so here in NC depending on where you are.
Think I got stuck?
140 tractors sell for $3000.00 to $6500.00 here depending on condition and shiny factor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
