H throttle action better

Posted by Farmall Ed on August 30, 2000 at 15:38:15 from (209.240.220.143):

A few days ago I posted a message concerning my erratic throttle operation. Thanks to The Red and others who responded I went into the governor area and the thrust bearing is a little loose but not much wiggle. I also got into the throttle shaft connection under the slanted plate and lined it up according to my manual, as close as I could. There seems to be some looseness in the throttle rod connection. With the speed control full open and the throttle rod up all the way (butterfly valve open) the pin would not slide in freely. I adjusted the connecting rod all it would adjust and put it together. The engine runs OK now and follows the throttle settings pretty well. I did put a slightly shorter governor spring in also. The governor seems to operate very well. I would like to know if I can buy a kit to go in the governor. It seems everything is worn exessively but I can make it now with what I have done especially in my operations. Thanks again for your help. Ed

Follow Ups:

• Re: H throttle action better Farmall Ed 16:29:40 08/31/00 (0)
• Re: H throttle action better The Red 04:15:30 08/31/00 (0)

Post A Followup Name: E-Mail: Subject: Re: H throttle action better Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]