Posted by cchig on November 04, 2011 at 16:57:21 from (76.118.14.146):
In Reply to: Farmall A timing posted by dab102999 on November 04, 2011 at 06:32:54:
when I timed my cub I removed number 1 plug,put your finger in the hole,turn engine over by hand until you feel air comming out of the hole.Now watch crank pully for notch on pully to line up with the pointer and stop there,Now install the mag, The slot should be about 2 oclock,Turn the mag all the way in to the engine, tighten the 2 bolts finger tight so you can still move it.Now slowly turn the mag away from the engine until you hear the mag snap.Tighten it there.The mag should be timed now you can line up the rotor with number 1 on the cap and you should be all set to start it, hope this helped, Wayne
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
