Posted by Lmack on October 26, 2011 at 08:52:19 from (74.176.39.65):
In Reply to: B seal holder posted by teddy52food on October 26, 2011 at 06:05:37:
I assume you are talking about the 3-bolt retainer at the end of the shaft (CIH # 48085DBX). A Picture may be helpful. You can go to Case International and get a complete parts list with diagrams. Are you sure you need the seal holder or do you need the shaft spacer that fits between the shaft and the seal (43630D)? FYI there is nothing but friction that holds this spacer in place and if you do not have a cover spacer (48087DB)or some type pulley on the shaft it is not unusual to loose the inside spacer. You need a cover spacer. See if the link below is helpful.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Stories From Old Farmer - by K. Pratt. Old Farmer, a.k.a. Dale Jensen began posting messages to our discussion forums at the grand age of 75. With extensive knowledge of farming and tractors, he valued the past and the ways that went with it. He shared these values with us until shortly before his passing. I spoke with Dale in his last days and requested his permission to share some of his stories with the readers of our magazine. He agreed, and provided the
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
