|
Farmall & IHC Tractors Discussion Board |
Re: CUB RAD. COVER?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wardner on August 25, 2000 at 09:18:32 from (63.23.216.123):
In Reply to: CUB RAD. COVER? posted by Randy on August 25, 2000 at 08:51:35:
I hope all you are pushing is a "little snow" this winter. If you are using the factory setup, you stand a good chance of breaking the engine casting near where the lower water pipe passes through. Cubs do not have enough weight to handle more than six inches of wet snow. Make sure the four bolts that connect the block to the front end are always tight. Think about making a plow frame that runs back to the drawbar or drawbar mounting holes. Don't even think about pushing back refrozen snow piles.
I would advise against restricting air flow to a thermosyphen cooling system.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
65 Massey FERGUSON DIESEL
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
