H Governor problem

Posted by Dan on August 23, 2000 at 05:11:31 from (199.176.179.4):

When making the adjustments on the governor of my "H" I ran into a couple of problems. I first adjusted the Idle stop screw, then the Speed adjusting screw, then when I tried the �synchrozing the governor to the carburetor linkage� I had to turn the adjusting block all the way down the connecting rod, and it would not go down far enough to allow the pin to go into the connecting rod housing like it states in the I&T Service manual.
Then when I tried to set the High Idle (No Load) speed I could only get 1650 RPMs max.
Are the two problems related? What can I do to correct the problem(s)?
Thanks for any help.
Dan

Follow Ups:

• Re: H Governor problem JIM 06:04:42 08/23/00 (0)
• Re: H Governor problem The Red. Nuther Pix 05:34:22 08/23/00 (0)
• Re: H Governor problem The Red. Nuther Pix 05:33:15 08/23/00 (0)
• Re: H Governor problem The Red 05:21:52 08/23/00 (6)
  • Re: Re: H Governor problem The Red 09:30:19 08/23/00 (4)
    • Re: Re: Re: H Governor problem Dan 09:55:52 08/23/00 (3)
      • Re: Re: Re: Re: H Governor problem The Red 10:29:03 08/23/00 (2)
        • Re: Re: Re: Re: Re: H Governor problem Dan 11:35:25 08/23/00 (1)
          • Re: Re: Re: Re: Re: Re: H Governor problem The Red Scrathing Head 13:18:31 08/23/00 (0)
  • Re: Re: H Governor problem Dan 06:14:15 08/23/00 (0)

Post A Followup Name: E-Mail: Subject: Re: H Governor problem Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]