Re: 400 front wheel bearing

Posted by big fred on August 22, 2000 at 07:47:10 from (12.13.226.15):

In Reply to: 400 front wheel bearing posted by Jon on August 21, 2000 at 16:57:38:

Jon, normal procedure is to torque it down (value is relatively unimportant, somewhere in the 35 ft lb range should do it) turn it a few turns, this seats the bearings while there is no load on them, then back it off and snug it up just a little past finger tight and install the cotter pin.

Follow Ups:

• Re: Re: 400 front wheel bearing Jon 08:27:22 08/22/00 (4)
  • Re: Re: Re: 400 front wheel bearing The Red 09:01:03 08/22/00 (3)
    • Re: Re: Re: Re: 400 front wheel bearing Jon 09:57:16 08/22/00 (1)
      • Re: Re: Re: Re: Re: 400 front wheel bearing The Red 10:16:30 08/22/00 (0)
    • Re: Re: Re: Re: 400 front wheel bearing big fred 09:22:02 08/22/00 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: 400 front wheel bearing Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]