|
Farmall & IHC Tractors Discussion Board |
Re: 300U remote
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wardner on August 17, 2000 at 19:00:12 from (63.23.215.184):
In Reply to: 300U remote posted by Joe on August 17, 2000 at 09:01:07:
If you have only one valve, you can only use a trip bucket type loader. You will need to put another IH valve on your reservoir to operate a full function loader. On the valve that you have now you will see two plugs. These are work ports that could run the lift cylinders on the loader. You may also have a selector shaft on the end of the valve. If you look carefully you will see that it can rotate to a "D" or "S" position. That means double acting or single acting. Double acting means that you will have down pressure if the cylinders have two ports. Here in New England, it seems like every 300U sold went out the dealer's door with a loader. They are very common.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
