Posted by JR FRYE on September 01, 2011 at 07:32:14 from (71.7.54.104):
Good morning Guys : How are ya?
This is my project for today: The Farmall M that I bought The light harness is really screwed up. The man that I bought the tractor from has taken out the light control knob and switch and the wiring is gone: But that is ok. Because I have another switch but it is a OFF/ON switch that will work for now. This is what I want to do so tell me if it will work ok:
1. I want to take one wire from all three gages { THE LIGHT} Wire put in a inline fuse And take it to the switch:
2. I want do the same with all three lights, the two head lights and the working back light. And take it to the switch, and add a inline fuse.
3. Then I want to go from the other side of the switch and go to the power source.
The reason for doing this is because if it is dark enough to use the back work light it is dark enough of use all of them. YA OR NA; By the way Guys I am no ARTIES but I get buy. MANY THANKS JR FRYE
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
