Re: H 12 volt conversion

Posted by Bob M on August 06, 2000 at 14:02:56 from (152.163.204.34):

In Reply to: H 12 volt conversion posted by sarge on August 05, 2000 at 15:21:07:

Sarge - If you wired it up per the diagram and the motor runs on when you shut off the ignition switch, the warning lamp has too high a current rating. Replace it with a 12 volt lamp rated at 150 to 200 milliamps. Most auto side marker and instrument panel lamps fall in this range and will work fine. (Examples: #164, #192, #1815)

The non-functioning ammeter probably has a stuck needle. Happens sometimes to ammeters when a little water gets inside 'em. Only fix is to replace the ammeter.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: H 12 volt conversion Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]