Posted by M Diesel on May 09, 2011 at 11:35:30 from (12.24.61.12):
In Reply to: Max pto speed on MD posted by sflem849 on May 09, 2011 at 06:53:48:
Quoting Removed, click Modern View to see
The main thing on an MD is that ball joint in the throttle linkage where the linkage turns down hill over the side of the engine. It never gets greased and wears badly, eventually forming a tongue and groove kind of thing. It creates artificial stops and won't let the travel go to both min and max anymore, just barely reaching both ends. Otherwise there are no stops except those inside the pump.
Standard on an IH ag pump is 11% regulation. Setting high idle is very easy, done by a screw under the pump oil filler cap. It's the one where the screw head goes to the right and the head bumps against the case. Screw it in a little to up the RPM.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Horsepower Defined - by Staff. Indicated Horsepower This represents the power developed in the enine cylinder as obtained from the pressure in the cylinders. This is pressure obtained from an indicator which shows cylinder pressures. Indicated horsepower does not represent the actual useful power delivered by the engine. Brake Horsepower This is the actual horse power delivered by the engine to the shaft. It is equal to the "indicated horsepower" less the friction of the engine. It is useful hor
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
