Posted by KenB_Texas on March 03, 2011 at 19:56:07 from (216.82.216.251):
I am trying to mount a C-12-D to my SC. I had it mounted this past weekend and it seemed to work well, except for the following problem. I have the lift link adjusted as short as it will go and still cannot get enough ground clearance. With the touch control at it"s max, the disks barely clear the ground by less than an inch or so. They drag the ground occasionally. After opening up a land and running the left wheel in the furrow the mount assembly also drags the ground. Obviously I am doing something wrong but I can"t for the life of me figure it out..
The Manual para #3 reads "attach the lift link to the hitch arm and to the inside hydraulic touch control arm." I have 2 SC"s and 2 C"s and none of them have more than one touch control arm on the right side of the tractor.
Am I missing a touch control arm? Did early C"s have two on the right? I have not seen one. any suggestions or ideas much appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Abe is Still Making Hay - by Jeremy Sweeten. Things have changed a bit since my last article. I am now almost finished graduate school at Purdue University. I am still in Agronomy, but specializing in hay and forages. My wife has survived two years of marriage to a part-time farmer. The equipment line up has changed a bit too. The DC has retired to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
