looking at the plug,,follow down the porcelan of the plug to where it enters into the steel,,,here you will see the steel begin, you will notice it is a radius,,that radius is a "roll=crimp" that is rolled by machine and seals the porcelan into the steel part of the plug.a lathe is great for cuting this radius off to make adapters out of plugs,,,at worst, a drill press with a 3/4 inch chuck will hold the plug and using a hand grinder or die grinder you can grind the radius away as the grinder takes the radius off-"not advisable to do as for safety concerns,,but i have using safety gear and care and skill"
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - On the Road with Dave Gohl: Tractor Club Beginnings - by Dave Gohl. I was surprised about a month ago when I got a call from a fellow tractor croonie. His message was interesting and to the point. He's says "Dave, I've been thinking about starting a Two Cylinder club for our area. What do ya think?" It was a loaded question. I said that I would be interested, and was wondering what his next step was. (Although I was talking under my breath, since I thought of this some years ago) My friend, Arlyn Lamb of Lakeville, Minnesota was sincere in his miss
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
