NO! It would have to be a real cherry for me to give it more than a passing glance. And if you plan on doing any haying with it, you WILL miss having 8 gears. Second is faster in them, too, so you would likely end up hating the 6 speed. The 15 worked good for us on the chopper, but we ran the diskbine with it one time, in heavy hay it was OK, but when it was lighter and you could pick up hi-2 with the 1066, you couldn't because hi-2 in a 15 runs about 2-3 MPH faster than a 10 or 1466. It's great for heavy tillage, too. But for an all-around tractor, not so much. Mind you, we also had the fuel cranked right to ours, on a cool still night chopping, it would send a plume of black smoke straight up through the hi-tension lines, and leave a smoke trail around the field.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
