Posted by Dean Olson on February 05, 2011 at 07:45:07 from (76.31.42.124):
In Reply to: super C power upgrade posted by Jessup on February 04, 2011 at 15:18:14:
With a smart operator a 6 ' shredder is not a problem for the Super C. I've been using one for a lot of years. If the brush is over your head you don't take a full 6' cut. You take only what the motor will handle. After I got the pasture nocked down the 1st time I'm now in maintenance mode and can take a 6' pass with good speed. The super C is a lot more fun and agile than an M.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 9N Lives Again - by Tyler Neff. I often reminisce about the good old days of my youth when I visited my grandparents on their farm in Moorefield, West Virginia. I lived in Middletown, Maryland, which was about two and a half hrs away from the farm. During my summer vacations I would spend two weeks helping granddad Wilmer with his farming duties. Wilmer and his brother Weldon owned the �Neff� farm. Th
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
