Farmall & IHC Tractors Discussion Board |
Re: Re: My M won't move!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Maury on July 12, 2000 at 09:48:27 from (12.10.107.130):
In Reply to: Re: My M won't move! posted by Brent on May 14, 1999 at 10:28:51:
I had the same problem with my Farmall M. The shift lever pin came part way out and the gears jammed. A prior owner had used a steel band to hold the pin in place. I purchased a new pin and found it was much shorter than the one I took out. It appears that something is missing if the new pin is to be used. Like a plugs or retainers at each end of the pin hole. For now I reinstalled the old pin that is flush with the outer edge of the holes and put the steel band back in place. Thanks in Advance for Suggestions
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|