Posted by Greenie727 on January 23, 2011 at 08:56:52 from (24.61.144.125):
The steering wheel on my 1945 Farmall A was bent when a support beam dropped on it due to a heavy snow load on the roof. No other damage to the tractor. I'd like to keep the original steering wheel as the Data plate on the tractor states MADE IN USA and thats the way I'd like to keep it. I have read other posts stating the aftermarket imported steering wheels do not look or feel as good as the originals. Several posts have claimed Minn-Kota company can resurface and repair the original wheel to like new condition. Will they be able to repair the bend to the dished spokes and recover the wheel to a like new original condition? If I send them the wheel will they repair and return this steering wheel or keep it as a core and return another steering wheel? Also, were the original wheels bare steel spokes or covered with rubber/plastic as it appears to look like in my Farmall A parts catalog? The wheel on this tractor which I believe to be original has bare steel spokes. Thanks for any advice or comments.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
