Posted by ericlb on January 14, 2011 at 13:57:10 from (12.189.32.54):
just thought id ask, my ford tractor ate its starter drive and it dont have the hand crank pulley so the little cub gets feeding duties, its got a danco c2 belly mower on it and no drawbar, but the mower has a hitch on it, im pulling about a 5 or 6 hundred lb trailer[ old 60's pickup bed with a trailer house axle] with 250 gallons of water on it at times and 2 small square bales of hay, several tools ect the usual junk, not having any problems, but the little cub knows its hooked to something, how much weight can the mower hitch take? its just a flat plate with 1 reinforcing angle brace on it, attached to the mule drive , thought id ask i dont want to mess up the cub
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
