|
Farmall & IHC Tractors Discussion Board |
Re: Re: Badly Pitted Bull Gear Tooth
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by cheg on July 07, 2000 at 05:31:38 from (199.240.150.128):
In Reply to: Re: Badly Pitted Bull Gear Tooth posted by The Red on July 07, 2000 at 04:55:29:
Since the pits are on the forward drive side of the active profile, what are your thoughts about switching the bull gears from side to side so the opposite (good) side of the gear tooth is used for forward? The pits would only be used during reverse. Do you have a ballpark figure for a bullgear?
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
