Posted by farmalldean on March 12, 2009 at 09:20:00 from (216.228.196.94):
Thanks to all of you who advised me on rebuilding the SA governor. I replaced all springs, bearings, seals and bushed the control rod hole in the governor case. At start-up I was a bit disappointed, however, I discovered that when I installed my new Zenith carb I put the conrol rod on so that it interfered with the carb. This limited how far open the throttle valve would go. I turned the rod 180 degrees and all was well. The governor now works just great!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - When Push Comes to Shove - by Dave Patterson. When I was a �kid� (still am to a deree) about two I guess, my parents couldn�t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He�s been run over by a train, he�s gone forever!" Where did they find me? Perched up on the seat of the tractor. I�d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this �green planet�. I�m par
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
