|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Another governor problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by big fred on July 06, 2000 at 13:15:46 from (12.13.226.12):
In Reply to: Re: Re: Re: Another governor problem posted by Douglas Stockman on July 06, 2000 at 03:31:10:
Hmmm, I guess I gotta look at that again, I plumb didn't notice that. I don't think I'd tear into mine to change it, since it works good. You should have some spring tension against the carb linkage with the engine off, though. By the way, I found that fixing my governor cost me about $600. That was about $75 in parts for the governor, a hundred or so for wheel bearings, gaskets, and miscellaneous parts (since it was out of service anyway), about $50 in spray bombs to repaint the whole tractor, and the rest for tools "I just had to have", including an air compressor. This old tractor stuff is fun! ;o)
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
