Posted by pintobill on December 28, 2010 at 16:06:55 from (174.253.132.57):
I started replacing the countershaft and input seals today on my H, I am hoping to have it finished tomorrow if the new seals come in at Napa. I am going to replace the old oil with new, can any body tell me approximately how much oil it takes from empty to refill all of it. Thanks in advance. I got quite a bit info already on changing the seals. I have been putting it off because of the talk about the coutershaft nut sometimes being very difficult to remove, but I started on it today. I put the tractor in high gear set the brakes and I used a craftsman prybar that was half inch stock, I stuck it in the nut, and gave it one good pull and it broke loose and spun off with my fingers. I may have gotten really lucky, but I was happy with how easy it came off. So again thanks for all the help.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Abe is Still Making Hay - by Jeremy Sweeten. Things have changed a bit since my last article. I am now almost finished graduate school at Purdue University. I am still in Agronomy, but specializing in hay and forages. My wife has survived two years of marriage to a part-time farmer. The equipment line up has changed a bit too. The DC has retired to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
