Posted by Dave H (MI) on December 19, 2010 at 09:42:32 from (205.188.116.73):
In Reply to: Re: more pics posted by farmallhal on December 19, 2010 at 07:33:09:
I just did a Cub that was a mower tractor for it's entire life and dripped every fluid possible from every place possible...get the picture? Filthy!
(1) Power Wash. (2)An old wire wheel in a drill over every inch of the tractor. (3) Power Wash (4) Remove everything you can (5) Power wash (6) Again with the old wheel (7) Yet another power wash (8) New wire wheel to remove paint and rust. Electolysis on some parts. Others went to the blaster. (9) Lacquer thinner in the sprayer and wash the whole thing down with it. (10) Oil and grease remover in the sprayer. (11) Paint.
Probably missed a few steps. Took literaly months to accomplish. Looks killer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A 1937 John Deere Unstuck - by Gary Hickman. Here is my story of how I got the pistons out of a 1937 JD B that the engine had been stuck for about 14 years: About 12 years ago my Dad gave me one of the tractors I ran as I was growing up on our farm in central Nebraska. The engine on this tractor, a 1937 John Deere "B", had been stuck for 2 years before he gave it to me. This last spring (1999) I hauled the tractor to our 2 acre lot in St. Libory Nebraska where it joined my antique machinery collection, at that time a 1929 Caterpillar T
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
