It's been a few years and I really don't remember. I did plow with a 3x16" F-H plow, but not very much. We had about 50 acres of irrigated corn for the trench silo and that's all we used the F-H plow for. I think I only plowed one day with the mounted plow. Mostly we baled alfalfa with it and an IH baler. We had 400 acres of alfalfa on the ranch and we baled almost every afternoon, with the 450 on the baler and a 350D loading and unloading bales on a big bale trailer (I think either 240 or 248 bales). There was a Farmhand accumulator on the baler and the bale pickup on the 350D loader. We would swath with a Cockshut swather in the mornings and bale in the afternoons.
I also pulled a 5x14" pull type plow a few days on spring wheat stubble and we pulled a 1 row IH chopper with the 450 filling the silo... I don't remember if I ever drove it while chopping corn, mostly I drove an old army 6X hauling the silage.
That 450 was the workhorse tractor on the ranch at that time... the 350D was used maybe 1/4 as many hours, but I drove it a lot handling bales. I don't recall the 450 ever causing a problem. We just changed oil, gassed it up (it did use a lot of gas) and worked the heck out of it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
