Re: Farmall M with no spark

Posted by Regularman on June 15, 2000 at 09:18:45 from (147.160.180.17):

In Reply to: Farmall M with no spark posted by Bart on June 14, 2000 at 14:47:32:

If I comprehended the story correctly, the tractor was running rough, you replaced the condenser, points and wire from the coil and now you have no spark, correct? If this is correct here are
A few things to check:

Be sure the wires from the coil and condenser are not touching the case of the mag where they are attached to the points. This sounds like your problem if you ask me.

Be sure the points are not grounded out at the base where they pivot.

Be sure the gear drive mechanism that drives the rotor is in time with the points. This can be installed on the shaft with the flat spot on it 180 degrees out of time.

Hope these suggestions help.

Follow Ups:

• Re: Re: Farmall M with no spark Bart 11:38:39 06/16/00 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Farmall M with no spark Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]