|
Farmall & IHC Tractors Discussion Board |
Re: Farmall M steering
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on June 13, 2000 at 08:20:19 from (192.232.120.194):
In Reply to: Farmall M steering posted by Ted on June 13, 2000 at 07:44:37:
Ted - Here's a few suggestions to figure out front wheel wobble: Jack up the front of the tractor at the frame. Then start at the bottom and work up... 1 - Check the front wheel bearings for looseness - adjust if necessary. 2 - Check for horizontal and vertical play in the lower bolster. If you find horizontal slack, the bottom bushing needs to be replaced. 3 - Remove the grille, then the cover from the steering box. Check for horizontal play in the upper end of the bolster shaft. Also check for worn out worm shaft bearings, and for a worn worm and sector gear. Any worn parts should to be replaced. From my experience, chances are pretty good your problem will be a combination of #2 and #3. Hope this helps...
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
