|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Super M 6v to 12v conversion
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ltf in nc on June 06, 2000 at 10:47:28 from (206.228.214.252):
In Reply to: Re: Re: Re: Re: Super M 6v to 12v conversion posted by The Red on June 06, 2000 at 09:39:52:
Red, Bob M is calling for a ballast resistor and not a voltage dropping resistor therefore he is using a 12 volt coil. With a dropping resistor he would be using the old coil and the coil would be as you stated. Since both resistors essentially do the same thing it is just the wording that further ID's the arrangement as to which coil is in the circuit. Ballast resistor with a 12 volt coil and a dropping resistor for using a 6 volt device on 12 volts. With a dropping resistor you would be correct and the coil would have been the old 6 volt one. For long life to the points you would still employ a ballast resistor after the dropping resistor. Cheers
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
