Posted by Owen Aaland on July 18, 2010 at 15:19:42 from (198.70.47.181):
In Reply to: Farmall H Starter!!! posted by Mark(EC,IN) on July 17, 2010 at 14:58:21:
Justin M said: (quoted from post at 13:33:39 07/18/10) [As a matter of fact, that stud is spinning. Is that a fix I can make?
What I do is remove the stud from the starter so I can do a good job of removing the old solder. Remove the solder from the ends of the field coils. Install the stud with only the inside insulator installed on the stud. Reshape the field coil ends to fit into the slot in the stud. Apply flux to the area you want to solder. Resolder the connection. After it cools a bit you can install the remaining insulating washers and reassemble the starter.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
