|
Farmall & IHC Tractors Discussion Board |
A Journals and Oil Pressure
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave on June 05, 2000 at 14:08:01 from (128.113.2.50):
I have a 41 A with really low (15 psi) oil pressure when hot (30 cold). Runs fine otherwise. I read all the posts in the archives, and am going to check the crank and rod bearings and oil pump end play with plastigage. When I do check the main journals, I'd like to mike the shaft at the same time. How do I do this with the crank in place since I was shown to "drag" the mike over the bearing surface to get a good measurement. Seems like even if I slip the upper shell out, I still won't be able to measure the thickest part of the crankshaft (Or can I?). Thanks in advance.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
