|
Farmall & IHC Tractors Discussion Board |
Re: Re: 6 Volt Regulator L post
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Barry Fogel on June 05, 2000 at 11:12:20 from (206.111.244.52):
In Reply to: Re: 6 Volt Regulator L post posted by Bob M on June 05, 2000 at 04:49:34:
Dear Bob,
First of all thanks for the great diagram.
Too bad you didn't do the ones in the IH manuals!
Given that I've gone back to the original setup ie: starting push rod switch on the starter motor, magneto and no starter button, would I still use the "L" terminal. Is that just for solenoid-starter button set-ups?
The only reason I'm asking is that in my manual it shows one wire in the harness going to the "F" terminal on the generator, one wire going to the "B" on the regulator and a jumper wire from the "G" on the regulator to the "A" post on the generator.
Was there a change in regulators or generators since 45?
Thanks for the tip on the ammeter test. Barry Fogel
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Generators - by Chris Pratt. As a companion to the articles on three-brush and two-brush generators, it seemed fitting that we should provide our readers with a description of how a generator works in lay terms. The difficulty with all those "theory of operation" texts is that they border on principles of electricity or physics and such. Since I know nothing of either, you will have to put up with looking at the common sense side of how generators work which means we "
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
