|
Farmall & IHC Tractors Discussion Board |
Re: IH W$ Charging the battery
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Red with picture on June 04, 2000 at 13:07:59 from (12.75.197.22):
In Reply to: IH W$ Charging the battery posted by Mahkel on June 04, 2000 at 12:53:04:
Use 10 gauge on the battery and field wires and 12 on everything else. On the VR, run a wire from the bat terminal to the right terminal on the ampmeter gauge with the gauge laying down. The field post on the vr goes to the field post on the genenrator. The gen post on the vr goes to the gen or a post on the generator. Run a wire from the field post of the generator to the bottom screw on the light switch assembly. The wire from the battery, via probably the starter switch goes to the left post on the ampmeter gauge. The coil wire and the lights wire bolt to the right ampmeter gauge post. Hope this helps.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Pop's Tractor of Gold - by Gary Teate. My father was a simple man but could repair just about anythin mechanical that was ever made. From the time I was a young boy growing up in Jacksonville, Florida, I would spend a considerable amount of time helping my father repair or rebuild equipment and engines, etc. on our 2 1/2 acre "spread". Pop always dreamed of having more acreage out in the country where he could retire and tinker as much as he wanted and often reminisced about his boyhood days on his grandfathers farm in Montecello,
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
