Posted by Farmallb on May 30, 2010 at 18:59:26 from (12.74.230.105):
Ive had my carb rebuilt, but it still dont start. Itall occasionally pop and puff,thats about it, then the plugs load up with gas and thats it. I know in my mind 99% that the problems in the carb, but that other 1% wonders if it might have a weak mag/dist. I dont remember which it is, as ive been busy on the other side of the tractor. Could the mag/dist suddenly throw out a weak spark to where the engine wouldnt fire hot enough to ignite the gas, and im useing Ethyel. I dont think that that should be the problem, because, even if it was, the carb loads up with gas, and even useing the choke VERY spareingly, (I stop chokeing it the first puff I get.), The gas just runs out of the carb. To satisfy the rebuilder, is there anyway I can tell if the spark is hot enough to do the trick, or not.
Normally, I would take it to a mag/dist shop and have it checked if it was on my H or Case, Them, I could take the hammermill belt and belt one to the other and just run the wires in correct order till it fired up. I dont know if I can run the belt with a cub, and I hate doing the timeing the tried and true way, ESPECIALLY on a Cub.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Magic Moments - by Tyler J. Woods. Magic moments don’t just happen. You have to help them along. This morning, I got up early. It is my day off from my regular workweek and I had a lot of things to do. It’s fall, and with winter coming on, there is a lot of work to do before weather closes in.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
