Posted by mkirsch on April 22, 2010 at 05:02:22 from (64.80.108.57):
In Reply to: H Ammeter Hookup posted by Doug Kieta on April 22, 2010 at 03:13:57:
Which terminal of the battery is connected to the frame of the tractor?
Bob M's diagram is for POS ground like Allan said. If you connected the NEG battery terminal to ground out of habit, that's why the ammeter is reading backwards. You can leave it that way, just swap the wires on the ammeter.
It sounds like it's charging, ammeter wired up, backwards, but it shouldn't be pegging the meter like that. That indicates something is wired wrong or your regulator is not working.
Did you leave the FLD and BAT jumpered together? You should only touch them together MOMENTARILY. Once they touch, the generator is polarized.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.