|
Farmall & IHC Tractors Discussion Board |
Re: Re: Best finish mower setup- 3 hilly acres?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Paul Shuler on May 26, 2000 at 18:12:29 from (152.163.197.53):
In Reply to: Re: Best finish mower setup- 3 hilly acres? posted by Jim on May 25, 2000 at 10:50:35:
I have a Super C with a NF end but no mower yet.Jerry it's a little smaller than an H and a little bigger than an A,B or cub. It seems to have plenty of power for a belly mower and if you don't live on a place with to steep of hills with that narrow front end you can turn it around on a dime.You might have to trim up your trees a little to keep from getting scuffed up by limbs,it sits a little higher than the smaller tractors.The best part is you can pick up a good one in the $1,200 to $3,000 range depending on how pretty you want it.
Paul
Paul
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
