Posted by mkirsch on March 29, 2010 at 05:29:06 from (64.80.108.55):
In Reply to: SH steering u-joint posted by GordoSD on March 27, 2010 at 15:47:37:
GordoSD said: How do I get the cross out of the shaft yoke?
C-Clamps, or remove the entire wheel/shaft/yoke assembly and do the work in your bench vise with some appropriately-sized sockets.
I can't remember exactly how we did it, but my Dad and I replaced the steering yoke on my SH with the entire assembly on the tractor. We used a combination of vise grips and C-clamps to press the old bearings out and press the new ones in.
I think we pulled on the opposing legs of the cross to pop each bearing cup out individually. They're just pressed in IIRC.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
