|
Farmall & IHC Tractors Discussion Board |
Re: Front Weigths for Farmal C single front wheel
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave on May 24, 2000 at 15:50:10 from (128.113.170.149):
In Reply to: Front Weigths for Farmal C single front wheel posted by Clarence Wisecup on May 24, 2000 at 11:58:11:
I may be way off base here but I remember seeing a safety video once on how a tractor's front end will rise up if the load it's trying to pull is attached too high. The advice was to always pull with the drawbar, and the drawbar had to be mounted lower than the center of the rear wheels. The idea is that if the load pulls back from near the top of the tractor (or anywhere above the rear axle), while the wheels push forward from low down in the tractor, the combination of the wheels pushing down low and the load pulling up high will rotate the tractor, lifting the front end. I don't pull, and you probably already knew that, but I thought I'd share it in case you didn't.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
History of the Nuffield Tractor: Conclusion - by Anthony West. In the last piece I mentioned that Nuffield had reached the stage where they had chosen to drop the "Universal" from production. The two new models were given three figure numbers, instead of "three" and "four". Model numbers were introduced to help farmers and dealers instantly recognize the engine size and horsepower of the tractor, the 4/60 had a four cylinder diesel engine which developed 60 bhp at 2,000 rpm. The 3/42 had a 3 cylinder diesel engine which produced 42 bhp at 2,000 rpm. Th
... [Read Article]
Latest Ad:
1952John Deere MT tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
