Posted by Spotted Horse on March 19, 2010 at 21:38:18 from (24.225.2.81):
In Reply to: Hydraulic question posted by Armand Tatro on March 19, 2010 at 03:35:27:
Armand Tatro said: (quoted from post at 03:35:27 03/19/10) What are you going to use the belt pulley pump for? You under stand that whenever you push the clutch the belt pulley stops thus no live hyd. You already have live hyd. with the M&W pump. With the hyd. reservoir in the loader frame I would think that should be good. Armand
I plan to get 2 sets of 2-way hydraulic outlets out of all this. The M&W live pump is VERY slow on the loader, and I don't want to take the loader off the M.
I know the belt pully driven pump will not be "live", but I think it'll work OK for pulling implements with hydraulic cylinders, (and with a little practice and fancy foot-work :wink: ) I think I can even use it on my JD 510 roundbaler and Hesston PT-10 moco.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Abe is Still Making Hay - by Jeremy Sweeten. Things have changed a bit since my last article. I am now almost finished graduate school at Purdue University. I am still in Agronomy, but specializing in hay and forages. My wife has survived two years of marriage to a part-time farmer. The equipment line up has changed a bit too. The DC has retired to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
