|
Farmall & IHC Tractors Discussion Board |
Re: Engine torque specs
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by Farmer Bob on May 03, 2000 at 21:28:10 from (207.227.187.109):
In Reply to: Engine torque specs posted by Greg on May 03, 2000 at 20:07:33:
Greg, The head torque is 65ft.lbs, the rods are as follows: If you have nuts locked with a cotter pin..40-45ft.lbs. If you have self locking nuts..43-49ft. lbs. The mains are 75ft.lbs. As with any torqueing technique it is best to pretighten all bolts to about 75% final torque, then go back and retighten to the correct setting. For the torquing of the head use a criss-cross pattern starting in the middle on one side then the middle across from the first, then back to original side and take next one then flop to opposite side of the other middle bolt etc. Work towards the ends of the head. Good luck..FB
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
