Posted by Dandy Dave on March 07, 2010 at 05:50:04 from (65.219.214.80):
In Reply to: 15-30 question posted by Hoss in Me on March 06, 2010 at 16:52:03:
I have a 1924 15-30 also. Casting date is 2/13/24. It ran an American number one saw mill for many years. I've used it on a blower when we had a Havest Day on my dads farm back in the early 80's. I use to oil the valves every day. There is a lot of differences to the later, post 1926 engines, and the early engine. Round governor housing, open governor control rods, Cast Iron front hub caps, multi disk clutch.... My tractor is on original steel wheels and has the heavy duty road wheels with angle iron style cleats. It runs good but is rusty, Someday I will restore it. I also have a casting date, 4/26/24, 10-20 that is a book end to it. Dandy Dave!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.