Posted by The tractor vet on March 06, 2010 at 19:21:34 from (75.19.124.251):
In Reply to: Re: Tool advice posted by Janicholson on March 06, 2010 at 18:25:52:
We will not go into how much i have in tools . And 3500 would not even make a good down payment . I had that much in tools back in 1964 . Had i lisen to the old Mac tool man back then it would have saved me lots of bucks as he wanted me to buy the master mechanic set way back then for 7800 and that set back then got you one of everything in the book. And back then they had a lot more of the big stuff . Where i worked i was put into a brand new Ford F350 4X4 that we set up as a service truck with welder tourches fuel &oil and a air compressor that would run two jack hammers . The boss also filled that truck with all Mac tools and a complete OTC puller set both screw type and Hyd up to 50 ton. plus a OTC track pin press . Now that was a real rolling tool box . You name it it was on that truck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.