Posted by BruceS. on January 23, 2010 at 14:26:40 from (76.15.41.143):
Got a new seat pivot shaft and bushings for an EZ Rider seat on my F30. The bushings had long since disappeared. How on earth does one put this thing back together? The bushings (tapered end goes toward tube, right?) will not even begin to start to go inside tube where seat pivots. I tried dish soap, silicone grease, but no luck. How are the bushings supposed to fit? Are they supposed to fit part way into the tube, or somehow squeezed together to fit into the outside bracket where the bolts on each end. The bushings are simply too big for the pivot hole. Someone must have an answer. BTW, as far as I can tell, the pivot shaft and bushings must be assembled at the same time. Bushings cannot be put in first. Any ideas welcomed, and sorry for long post. I guess I'm venting a bit.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Major Problems - by Anthony West. Following the aquisition of the two Fordsons to my collection I found that I was struggling to move them about. I had considered the possibility of driving the "F" to and from shows but anything other than local rallies was totaly impractical due to its sedate pace. I had also considered buying a landrover and trailer, but the price of a
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
