Ok, no problem, I apologize for the misinterpretation.
Unfortunately I cannot cast anything more than gray cast at my facility and of very limited size due to it being teaching environment and the model of the furnace I have.
Some universities have the capability of casting iron and steel but I would guess very few due anymore due to the expense of the equipment and the safety/liability involved.
Back on topic with the "power steering" emblems - i'm guessing now that these ARE made of sheet metal but are stamped to get the slightly raised surface of the lettering and trim?
If you could get me the dimensions (inside & outside diameter would be enough) I could probably recreate a couple of these with a computer cut stencil on sheet metal. It wouldn't have the raised surface but would otherwise look like OEM.
This post was edited by Stephen McCoy at 05:45:31 12/28/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - On the Road with Dave Gohl: Tractor Club Beginnings - by Dave Gohl. I was surprised about a month ago when I got a call from a fellow tractor croonie. His message was interesting and to the point. He's says "Dave, I've been thinking about starting a Two Cylinder club for our area. What do ya think?" It was a loaded question. I said that I would be interested, and was wondering what his next step was. (Although I was talking under my breath, since I thought of this some years ago) My friend, Arlyn Lamb of Lakeville, Minnesota was sincere in his miss
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
