Posted by farmallhal on October 27, 2009 at 09:38:50 from (76.4.163.116):
In Reply to: Thinking of Hugh posted by Paul Shuler on October 27, 2009 at 09:18:56:
Paul, nice to see your post and yes I certainly remember that string we had going. I was almost certain we were going to have a visit with Hugh after that exchange. I always kidded Hugh about his legs and such. I must have at least 20 off forum emails in a folder that Hugh sent me. He was certainly one of the bright spots on this forum and knew those offset tractor better then anyone I know. He had a lot of good stuff to discuss and always had time for me whenever I needed some information. He was certainly a pleasure to exchange notes with and just wish we could have met up at a RPRU along the way but just couldn't pull it off. Take care and I'll send you a note one of these days and share some information on what's going on up this way. Hal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Ford 600 Series - by Staff. The Ford 600 Series tractors bean production in 1954, and continued until 1957. Quite similar to the Ford NAA (Golden Jubilee) in design, it used the same 132 cubic inch Red Tiger engine with 31 horsepower. Several different models were made in the 600 Series, and these numbers were used to denote whether they used a particular transmission, hydraulic system, or PTO. The result was five different model numbers: 620, 630, 640, 650 and 660. These break down as follows:
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
