Posted by Linemanfarmer on October 10, 2009 at 20:41:59 from (68.103.100.34):
Hi guys,
Well a couple of days ago I posted....Is it possible to put Dual exhaust on a Farmall. Well everyone did not disagree. Im not sure if there are any Farmalls out there that do have it, if so, let me know. But as far I am considering, I have the first that I know of! I worked most the afternoon and up to 10:00 to here it run. Wow, it sounds like its on steroids! Go to youtube and look up my handle linelizard1021. This made me very happy to here it run. I still have to make a bracket to hold the new exhaust outlet, and cut a hole in the hood. But it is similar to headers and I fought it the whole way. Used a couple of 1 1/4" elbows and old header pipe (pre-bent) and a 2" pipe for the outlet. But go and watch the video I'll try to post.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
