Posted by Roger46 on September 24, 2009 at 16:30:12 from (70.219.191.134):
In Reply to: 3point on M Famall posted by Jerry RV on September 24, 2009 at 15:16:24:
I have an aftermarket 3 point on my Super H. It has places for two cylinders, but I only have one 3" cylinder on mine. If you only have a single 2" cylinder I can see why it will not lift a bale as those belly pumps only put out 500 - 800 psi depending on the model (if you do the math, a 2" cylinder only has an area of about 3 sq inches x 800psi = 2400 lbs force vs about twice that for a 3" cylinder). I have a fork attachment for mine and was able to lift almost 2000 lbs. However, I need my loader on to keep the front end on the ground. If your 3 point will accept a second cylinder, I would do that otherwise replace the existing one with a 3 or 4 inch one. Roger
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Removin Broken Bolts - by Staff. Another great discussion from the Tool Talk Discussion Forum. The discussion started out with the following post: " How would I remove a bolt thats broken off in a piece of metal and I want to save the treads in the metal and then put in a new bolt. "
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
