Posted by bob from ill on July 30, 2009 at 20:01:56 from (209.102.178.45):
In Reply to: 806 pto leaks posted by bob from ill on July 29, 2009 at 19:21:17:
the origanal housing had a crack by bolt flange and was seaping oil out for a few years. finally decided to repair. tried to weld crack but kept shrinking and a crack would form again. anyways, got a used replacement btu it had the seals removed already. I was able to press out my seals, there was a couple of chips in otherhousing where someone wasnt careful removing seals. pressed in seals, niether leaked from rubber element but it leaked where the chips were. since it wasnt a pressure leak, I applied permatex cold weld, same as jb weld. if it didnt work i wasnt out anything but ten minutes it takes to harden. it worked like a charm.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Major Problems - by Anthony West. Following the aquisition of the two Fordsons to my collection I found that I was struggling to move them about. I had considered the possibility of driving the "F" to and from shows but anything other than local rallies was totaly impractical due to its sedate pace. I had also considered buying a landrover and trailer, but the price of a
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
